TM110-3+1P 型四工位管端成型机
TM110-3+1P FOUR-STATION TUBE END FORMING MACHINE
1、本机为大管径成型设备，最大加工管径 φ110x3( 铜管 )。2、四柱油压夹紧，冲头卧式布局，操作方便，可实现异形管的管端加工。
3、夹模高低及左右两个方向可便调整，保证夹模与封口模的同心度。
4、四工位加工：三个管端工位一个平口工位，工位切换采用伺服电机驱动。
1.This machine is a large pipe diameter forming equipment, the maximum processing pipe diameter is
φ110x3 (copper pipe).
2. Four-column hydraulic clamping, horizontal punch layout, easy to operate, can realize pipe end processing of special-shaped pipe.
3. The height of the clamping mold and the left and right directions can be easily adjusted to ensure the concentricity of the clamping mold and the sealing mold.
4.Four-station processing: three pipe-end stations and one flat-end station, and the station switching is
driven by a servo motor